Dyna-Glo TT15CDGP Manuel d'utilisation et d'entretien télécharger pdf (Page 9)

CONNECTING HEATER TO PROPANE TANK

Read and understand all safety information before connecting heater to propane tank.

1. (Applies to dual burner models only). Place heater onto tank with tank collar bracket over tank collar (Fig. 1)

Mounting bolt knob should be positioned to the outside of tank collar and be positioned as closely as possible

directly opposite to the cylinder valve outlet. See Figures 1 and 2.

2. (Applies to dual burner models only). Firmly secure to tank by hand-tightening mountingbolt knob.

Do not overtighten mounting bolt knob.

3. Make sure heater regulator knob is in the OFF position.

4. Insert regulator’s connector into tank’s valve outlet tting and turn left (counterclock-wise) until fully tightened.

Threads are left-handed. (Figure 3.)











5. For single burner models loosen the wing bolt securing the support leg and position it rmly on

the surface of the cylinder. Tighten wing bolt rmly.

6. Open propane tank valve slowly by turning counterclockwise .

7. Check all ttings for leaks. Apply a 50/50 mixture of liquid soap and water to all joints. Bubbles forming

show a leak. Correct all leaks at once.

8. Always remove propane tank from heater after each use. Do not store heater while attached

to propane tank.

WARNING: NEVER USE AN OPEN FLAME TO CHECK FOR LEAKS.

PROPANE TANK TOP HEATER

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Pas de commentaire

Dyna-Glo TT15CDGP Manuel d'utilisation et d'entretien Page 9