Dyna-Glo RMC-KFA120TDLX Manuel d'utilisateur télécharger pdf (Page 7)

12

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

F.) SPARK PLUG

CLEAN AND REGAP EVERY 600 HOURS

OF OPERATION OR REPLACE AS

NEEDED.

-Remove upper shell(See 10 page).

-Remove Fan Blade(See 11 Page).

-Remove Ignitor Wire from Spark Plug.

-Remove Spark Plug from Burner Head using

medium phillips screwdriver.

-Clean and regap Spark plug electrodes to

0.140″(3.5mm) gap.

-Reinstall Spark Plug in Burner Head.

-Attach Ignitor wire to Spark Plug.

-Reinstall Fan and Upper Shell.

G.) PHOTOCELL

CLEAN PHOTOCELL ANNUALLY OR AS

NEEDED.

-Remove upper shell(See page 10).

-Remove fan (See page 11).

-Remove photocell from photocell bracket.

-Clean photocell lens with cotton swab.

TO REPLACE:

-Disconnect switch wires from power switch.

-Remove two Screws using medium phillips

screwdriver.

These Screws attach Main PCB to Side

Cover.(See Figure 17)

-Remove Side cover(R).

-Disconnect Photocell Connector from Circuit

Board and remove photocell.

-Install new Photocell and connect photocell

connector to Circuit Board.

-Replace Circuit Board to Side Cover(R) and

Switch wires to Power Switch.

-Replace Fan and Upper Shell.

Figure 16. Removing Spark Plug

Figure 17. Replace & Cleaning Photocell

11

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

D.) FAN BLADES

CLEAN EVERY SEASON OR AS NEEDED.

-Remove upper shell(See 10 page.)

-Use 1/8" allen wrench to loosen set screw

which holds Fan Blade to motor shaft.

- Slip Fan Blade off motor shaft.

-Clean Fan Blade using a soft colth moistened

with kerosene or solvent.

-Dry Fan Blade throughly.

-Reinstall Fan Blade on motor shaft. Place Fan

Blade hub flush with end of motor shaft.

-Place Set Screw on flat of shaft. Tighten Set Screw

firmly(40~50 inch-pounds/4.5~5.6 N-m).

E.) NOZZLE

REMOVE DIRT IN NOZZLE AS

NEEDED(See Page 14)

-Remove Upper Shell(See page 10).

-Remove Fan Blade(See Fan Blades).

-Remove Fuel and Air Line from Burner Head.

-Remove Ignitor Wire from Spark Plug.

-Remove three Screws using medium phillips

screwdriver and remove Burner Head from

combustion chamber.

-Remove Spark Plug from Burner Head using

medium phillips screwdriver.

-Carefully remove Nozzle from Burner Head

using 5/8" socket wrench.

-Blow compressed air through face of

Nozzle.(this will remove any dirt in Nozzle)

-Reinstall Nozzle into Burner Head and tighten

firmly. (80~110 inch-pounds)

-Reinstall Spark Plug in Burner Head.

-Attach Ignitor wire to Spark Plug.

-Attach Fuel and Air Line to Burner Head.

-Reinstall Fan Blade and Upper Shell.

Figure 14. Fan and Setscrew Location.

Figure 15. Removing Nozzle

1 2 3 4 5 6 7 8 9 10 11 12

Commentaires sur ces manuels

Pas de commentaire