Dyna-Glo RMC-KFA75TDGD Manuel d'utilisateur télécharger pdf (Page 7)

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

4. KEROSENE (1-K)

For optimal performance of this heater, it is strongly suggested that 1-K kerosene be used. 1-K kerosene has

been refined to virtually eliminate contaminants, such as sulpher. Which can cause a rotten egg odor during

the operation of the heater. However, #1 diesel/fuel oil may also be used if 1-K kerosene is not available.

Be advised that these fuels do not burn as clean as 1-K kerosene, and care should be taken to provide more

fresh air ventilation to accomodate any added contaminants that may be added to the heated space.

KEROSENE SHOULD ONLY BE STORED IN A BLUE CONTAINER THAT IS CLEARLY

MARKED “KEROSENE”. NEVER STORE KEROSENE IN A RED CONTAINER.

Red containers are associated with gasoline.

NEVER store kerosene in the living space. Kerosene should be stored in a well ventilated place outside the

living area.

NEVER use any fuel other than 1-K kerosene (#1 fuel oil is an acceptable substitute.)

NEVER use fuel such as gasoline, benzene, alcohol, white gas, camp stove fuel, paint thinners, or other oil

compounds in this heater. These are volatile fuels that can cause an explosion or uncontrolled flames.

NEVER store kerosene in direct sunlight or near a source of heat.

NEVER use kerosene that has been stored from one season to the next. Kerosene deteriorates over time.

“OLD KEROSENE” WILL NOT BURN PROPERLY IN THIS HEATER.

Figure 8. Assembling Handle, Wheel and Cord wrap, Louver

CAUTION : DO NOT OPERATE heater without support frame assembled to tank.

NOTE : Heater should be inspected before each use, and at least annually by a qualitied service person.

Hot Air Outlet

Fuel Tank Flange

Nut

Wheel Support Frame

Wheel(Solid)

Cap Nut

Louver

Nut

Rear Handle

Air Inlet

Axle

Wheel Bushing

Flange Screw

Cord Wrap

Screw-S

Screw-L

Front Handle

Screw

1 2 3 4 5 6 7 8 9 10 11 12 ... 75 76

Pas de commentaire

Dyna-Glo RMC-KFA75TDGD Manuel d'utilisateur Page 7