Dyna-Glo RMC-KFA70TDGP Manuel d'utilisateur télécharger pdf (Page 14)

NEVER LEAVE THE HEATER

UNATTENDED WHILE BURNING!

H.) FUEL FILTER

CLEAN OR REPLACE TWICE A HEATING

SEASON OR AS NEED.

-Remove upper shell(See 10 page).

-Remove Fan Blade(See 11 Page).

-Pull Fuel Line off from Fuel Filter Neck.

-Remove Fuel Filter.

-Wash Fuel Filter with clean kerosene and replace

in tank.

-Attach Fuel Line to Fuel Filter Neck.

-Replace Fan Blade and Upper Shell.

I.) PUMP PRESSURE ADJUSTMENT

-Start Heater(See Operation, Page 8) and allow

motor to reach full speed.

-Adjust Pump Pressure.(Using a Flat blade

screwdriver)

Turn Relief Valve clockwise to increase pressure.

Turn Relief Valve counter-clockwise to decrease

pressure.

Set Pump pressure according to the chart below.

-Stop Heater(See Operation, Page 8).

NOTE: USE ONLY ORIGINAL EQUIPMENT REPLACEMENT PARTS.

USE OF ALTERNATE OR THIRD PARTY COMPONENTS WILL VOID ANY WARRANTY

AND MAY CAUSE UNSAFE OPERATING CONDITION.

Relief Valve

Pressure Gauge

Fuel Filter

Fuel Line

Figure 20. Removing Fuel Filter

Figure 21. Adjusting Pump Pressure

MODEL PUMP PRESSURE

RMC-KFA70TDGP 3.7 psi

RMC-KFA125TDGP 5.5 psi

RMC-KFA170TDGP 6.5 psi

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Pas de commentaire

Dyna-Glo RMC-KFA70TDGP Manuel d'utilisateur Page 14